Descargar Imprimir esta página

Am/Fm Radio Operation - Insignia NS-A1113 Guia Del Usuario

Sistema de audio tipo ejecutivo con dvd

Publicidad

Idiomas disponibles

Idiomas disponibles

AM/FM Radio operation

1 Enter FM/AM mode
In Turn-on or Play modes, press the FM/AM button on the remote
control to enter FM status. Press this button again to enter AM
status.
2 Select bands
Directly input the frequency: press the T/F button on the
remote control, then input the frequency that you want. The
range of FM frequency is from 87 MHz to 108 MHz. The range
of AM frequency is from 520 KHz to 1720 KHz.
Select the band by pressing the Tune- or Tune+ button. Press
the button to adjust the frequency up or down a step. The FM
increments are 0.05 MHz and the AM increments are 10 KHz.
Select saved stations by pressing the number buttons. For
example, press the 10+ button twice and the 5 button once to
select the 25th saved station. Press the CH- or CH+ buttons to
switch to the next saved station.
Automatically search bands. Press the Search button. The
system starts searching bands from low to high frequency. The
searched bands are automatically saved. Press this button
again to stop searching.
3 Save bands
Press the Save button. A lock icon appears on the display. For
example, if you want to save 99.3 MHz in the 28th save slot, press
the 10+ button twice, the 8 button once, press the T/F button to
input 9 9 3, then press the Save button.
4 Soundtrack selection
To select Mono or Stereo while in FM mode, press the
L/R(MO/ST) button. When you select Stereo, the display shows a
stereo signal. If the signal is not strong enough, you cannot select
Stereo.
Note
5 Exit FM/AM mode
Press the Play/Enter button to exit FM/AM mode and enter disc
play mode.
6 Vary the antenna direction to find the strongest signal for each
station.
20
Stereo is not available in AM mode.
www.insignia-products.com
NS-A1113 DVD Executive Shelf System

Publicidad

Solución de problemas

loading