Power Take-Off; Rear Power Take-Off For Mod.26Rs-30Rs; Rear Power Take-Off; For Mod. 45Rs-40Rs-40Sn-30Sn-40Sn-30A-40A-45R - GOLDONI EURO RS Serie Manejo Y Cuidado

4.8 POWER TAKE-OFF

Max stress on PTO (torque): 48 Kgm
See fig.28:
Couple implements with ratio not lower than 3.4:1 and cardan joint with
limit safety device of max. 48 Kgm.
If implements that produce a great deal of inertia (e.g. lawn mowers,
brush-wood choppers, etc.) are connected to the PTO, it is advisable to
use a cardan shaft transmission with "free wheel" device. As it prevents
drive from being transmitted from the implement to the machine, this device
allows these latter to immediately stop as soon as the clutch is depressed.

4.8.1 Rear power take-off for Mod.26RS-30RS

The tractor is equipped with a single power take-off with 1"-3/8 and clockwise
rotation.
Disengage the clutch by depressing pedal N° 19 fig.1.
Engage the power take-off by means of lever N° 14 fig.1 in the 540 RPM
position or in the position where it is SYNCHRONIZED with the ground speed of
the tractor.
Engage the clutch by releasing pedal N° 19 fig.1.
Synchronized power take-off
Synchronized with all the gearbox speeds. Used for trailers with driving wheels.
The power take-off is engaged in the following way:
Lever on point A to remove the impediment
Lever N° 14 fig.1 (n.1 fig.6) in the synchronized position (N° 3 fig.6)
Wheel turn / power take-off ratio: 1/15.13

4.8.2 Rear power take-off

for Mod. 45RS-40RS-40SN-30SN-40SN-30A-40A-45R

The machine is equipped with two rear power take-offs operated by the same
controls and with the same speeds. The only variations:
Top power take-off: 1" 3/8 profile, clockwise rotation
Bottom power take-off: 26UNI220 profile, anticlockwise rotation.
Rear power take-offs are controlled by means of lever N° 14 fig.1, which can be
set in the following positions:
• Independent 540-750 (position N° 2 fig.6 )
• Synchronized (position N° 3 fig.6)
93