Front Pto; Power Lift; Use With The Hydraulic Valve System; Use With The Electrohydraulic Valve System - GOLDONI IDEA Serie Manejo Y Cuidado

540/2000 Rpm rear PTO).
Speed: 2000 Rpm with engine at 2800 Rpm (this PTO is combined with the
540/2000 Rpm rear PTO).
The mid PTO can be engaged separately from the rear PTO.

4.7.2 Front PTO.

(Optional)
The front PTO is engaged with knob n.22 fig.1:
• Set the engine at less than 1800 Rpm.
• Push down on knob n.22 fig.1 and turn it clockwise.
The front PTO is automatically disengaged when you press knob n.22 again.
Form: 1" 3/8 ASAE a 6 splines
Turning direction: anticlockwise
As an alternative, one of the following ratios can be installed on the tractor:
Speed: 1000 Rpm with engine at 2588 Rpm
Speed: 1600 Rpm with engine at 2226 Rpm
Speed: 2000 Rpm with engine at 2692 Rpm

4.8 POWER LIFT

The tractor is equipped with a double rear power lift control system:
• Control with hydraulic valve system N° 34 fig.1
• Control with electrohydraulic valve system N° 10 fig.1
The controls are in parallel, thus both the hydraulic valve system lever and the
electrohydraulic valve system control can be used to lift and lower the rear
power lift.
The two controls cannot be used at the same time.

4.8.1 Use with the hydraulic valve system

Keep the electrohydraulic control N° 10 fig. 1 in the neutral position (central) and
use the lever N° 34 fig. 1 to operate the power lift.
The power lift lowers and remains in the float position when the lever is moved
down. Raise the lever to lift the power lift to the desired position.
The electrohydraulic valve system is inhibited and cannot control any operation
when the lever is down.
Warning: when the lever is moved down, the power lift will lower even
when the engine is off.

4.8.2 Use with the electrohydraulic valve system

Use switch N° 10 fig. 1, keep the red button at the top depressed and operate
the front switch on the lever to use the power lift. The power lift lowers and
82