VDO OceanLink 7 Instrucciones Para El Uso página 62

Alarm management
Alarms on several displays
If there are several OceanLink displays on the NMEA 2000 network, simply configure alarms from one
of the devices. Configuration is automatically transmitted to the others.
When an alarm triggers, the Alarm page appears on all displays. After acknowledging the alarm from
one device, the page disappears on all others.
Menu description ALARMS
Depth shallow
Depth navigation
Wind
Battery
Engine water temp
Engine oil temp
Engine oil pressure
Fuel
Fresh water
Waste water
Local alarm input
Min RPM
CAN
62 7" TFT display | Operating instruction v. 1.0 | © 2018 Continental Automotive Switzerland AG
Alarm
Low water minimum threshold
Maximum threshold. For example, a value near the maximum
value measurable by the sensor.
Safety depth minimum threshold
Wind speed maximum threshold
Battery voltage minimum threshold
Water temperature maximum threshold
Engine oil temperature maximum threshold
Engine oil pressure minimum threshold
Fuel level minimum threshold
Fresh water minimum threshold
Waste water maximum threshold
Connected digital sensor alarm (low active alarm). Refer to the
Installation instructions.
Engine revolutions minimum threshold. Only values under the
threshold will be considered to trigger engine alarms.
Alarm access from CAN bus (NMEA 2000 and J1939). See
"Managed alarms list" on the facing page
Description
Possible
Default
values/commands
0–9.9 m
2 m, buzzer Yes
0 – 99.9 m
50 m, buzzer No
0 – 99.9 m
5 m, buzzer No
0 – 99.9 km/h
39.9 km/h,
buzzer No
0 – 32.9 V
10.8 V, buzzer
Yes
0 – 139 °C
110 °C, buzzer
Yes
0 – 149 °C
120 °C, buzzer
Yes
0 – 9.9 bar
0.5 bar, buzzer
Yes
0 – 99 %
20 %, buzzer
Yes
0 – 99 % m
20 %, buzzer
Yes
0 – 99 %
80 %, buzzer
Yes
- -
0 -990 rpm 300 rpm
- -