Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – Field Install Surface Mount Kits – 2' x 2', 2' x 4', 1' x 4' and 1' x 2'
Installation Instructions:
1.
Using the appropriate dimensions and fasteners
described in Hole/Access Plate Locations (Diagram 1
and 2), rough in junction box and loosely secure the
surface mount frame to the ceiling. Ensure the frame
is square prior to fully securing the frame to the ceiling.
Slots will allow for adjustment once the frame is
attached. (see Figure 1)
2.
Remove one end plate on one side of surface mount kit.
(see Figure 2)
3.
Insert the luminaire two-thirds of the way in surface
mount kit. (Lift and slide the luminaire along surface
kit to avoid damaging the door frame latches). Make
all electrical connections according to local code. (see
Figure 3)
4.
Insert the luminaire in the surface kit. The fixture will
rest on the bottom flange of the surface mount kit on all
four corners. If the fixture is not resting properly on the
bottom flange, lift it up and shift it until it rests into place.
(see Figure 4)
5.
Reattach the endplate to the surface mount kit. The end
cap only attaches in one direction. Ensure the endplate
snaps are properly engaged. Attach with #10 screws if
necessary. (see Figure 5)
Installation completed. Fixture is ready to power on.
Figure 1.
Figure 2.
4
EATON
ADF142843
Installation instructions
Figure 3.
Figure 4.
Figure 5.
WARNING
The weight of the luminaire (ONLY) not to exceed 40 lbs.
Publicidad
