Samsung RH29 Serie Manual De Instrucciones página 26

Downloading the E-Smart App and
Connecting the Refrigerator to your
Network
1, On your Smartphone, connect to the app store
(e.g. Google Play, etc.).
2, Search for the app using "Samsung E-Smart
Ref." as the keyword.
3, Download the app and install it on your phone,
4, Launch the app,
The network configuration screen appears.
5, Configure the AP information (SSID, Password,
etc.) on the app screen.
6, Configure the network settings according to the
instructions in the app.
7, On the refrigerator, press and hold the Fridge
and Energy Saver buttons at the same time for
3 seconds.
The refrigerator enters the AP mode.
8, if you have completed the network settings
properly, the app shows the home screen,
Please confirm your Internet devices (AP,
Smartphone) are working properly before
configuring the network settings,
This refrigerator supports the IEEE 802,11
a!b/g/n protocols.
Samsung Electronics recommends IEEE
802.11 n.
To connect the refrigerator to a wireless
network, you have to connect the refrigerator to
an AP (router or modem).
if the AP supports DHCP, you can connect the
refrigerator to the Internet using DHCP or a
fixed IP address.
Set the channel of the AP to one not currently
being used.
if the channel set for the AP is being used
by another device nearby, it may result in
interference,
Most wireless networks allow you to configure
network security settings.
if your network has a security password, you
must enter the password to connect to the
network.
• The refrigerator supports the following wireless
security modes and encryption types:
Security Mode: WEP, WPAPSK, WPA2PSK
Encryption Type: WEP, TKIP, AES
(WPA2PSK and AES are recommended,)
The app supports indoor control only.
The Samsung E-Smart Ref, app is optimized
for Samsung Electronics Smartphones (Galaxy
$4, Galaxy Note 3).
For other Smartphones, some functions may
work differently.
Supported Wireless Channel is 1 to 11,
Engl sh --26