MTD 020 Serie Manual Del Operador página 10

Lower Handle
NOTE: Use hardware shown in Figure 3-3 from the hardware pack
to attach the lower handle.
Qty. 2
Hex Screw
1. Place the lower handle over the deck and align the holes on
the deck with the corresponding holes on the handle.
2. Secure the lower handle to the deck using the hex screws
(1/2-in. socket wrench), shoulder screws (5/8-in. socket
wrench), and flange lock nuts (1/2-in. socket wrench).
See Figure 3-4.
Shoulder
Screw
Hex Screw
Wheels
NOTE: Use hardware shown in Figure 3-5 from the hardware pack
to attach the wheels.
Qty. 4
10 S 3 — A
ection SSembly
Qty. 2
Shoulder Screw
Qty. 4
Figure 3-3
Flange Lock Nut
Figure 3-4
Qty. 4
Qty. 4
Figure 3-5
& S -U
et p
The holes in the deck (shown in Figure 3-6 and Figure 3-7)
provide three cutting heights. Use corresponding holes when
attaching all four wheels (i.e. for the lowest cutting position,
assemble each wheel at the highest hole on the deck).
See Figure 3-6.
Figure 3-6
1. Secure each wheel to the deck with the shoulder screws
(3/4-in. socket wrench), washers, and flange lock nuts (9/16-
in. socket wrench). See Figure 3-7.
Wheel Holes
Shoulder
Screw
Figure 3-7
Low
Medium
High
Flange
Lock Nut
Washer