Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Pump
•
Before doing any maintenance work, depressurise the water system and isolate the pump from all energy sources.
•
When the jobs are done, before restarting the pump, check that no tools, rags or other materials have been left close
to moving parts or in hazardous zones.
•
Replace any excessively worn components with original parts and use the lubricants recommended by manufacturer.
•
Dispose of the worn-out components and lubricants in accordance with the relevant statutory requirements.
•
Carry out the routine maintenance procedures specified by the manufacturer to keep pump safe and performing well.
Frequency
Every working day
Every 50 working hours
Every 500 working hours or
every year
Every 1000 working hours
(1) This interval refers to the first oil change only
Checking pump oil level (See Fig 21)
•
Check the oil with the pump level and cold.
•
Check the amount of oil through the level gauge (A).
•
If necessary, top up with oil with the characteristics specified in the "Comparison table of lubricants".
•
To top up with oil proceed as described below. Unscrew the plug (B) and pour oil in until it is halfway up the level
gauge (A), screw on the plug (B).
FIG 21
MAINTENANCE
Scheduled service table
Component
Filter
Pump
Connection to engine
Pump
Pipes and connections
Pump
Pump
Pump gaskets
Valves
Procedure
Inspect filter cartridge
Oil level check
Inspection visually
Inspect mounting
Inspection
Oil change (1)
Oil change
Replacement
Replacement
FIG 22
22
Reference
See "Inspecting the filter"
See "Checking the oil level"
See "Inspecting the pump
mounting"
See "Inspecting the
connections and pipes"
See "Changing the oil"
See "Changing the oil"
Contact an authorised service
centre
Contact an authorised service
centre
Publicidad
Capítulos
Tabla de contenido
