Mounting The Monitor Onto The Wall - Marmitek DOORGUARD 450 Modo De Empleo

Mounting the monitor onto the wall.

x
Route the cable to the place where the monitor will hang. (Note:
there must be an outlet nearby).
x
Mount the wall plate onto the wall using the four supplied
screws.
x
Take the monitor and secure the cable's 4 U-connectors in the
correct order under the 4 connectors.
x
Connect the power adapter with the backside of the monitor.
x
Now place the monitor against the wall plate and move it up and
down against the plate such that it snap-locks onto the plate.
x
Insert the adapter into the outlet.
x
You can always slide off the monitor by sliding it upwards.
x
Your DoorGuard 450™ has now been installed successfully and is
ready to use.
8 © MARMITEK