Assembly - Dimplex DWOP20R Manual De Instrucciones

Assembly

1. Carefully unpack all of the
components from the box.
(Figure 5)
2. Remove top cover by turning
the retaining tabs on both
ends of the water reservoir.
(Figure 6)
3. Install the light bulbs by
aligning the pins on the bulbs
and the fixture and pressing
down until they are fully
inserted. (Figure 7)
4. Install the transducer so that
it is sitting level in the circular
Figure 5
Rock
Media
Remote
Control
Media Tray
Transducer
Light
Bulbs Removable
Refill
Container
Figure 6
Top
Cover
holding area in the reservoir.
5. Orient transducer wire so that
it does not sit directly above
the emitter and the wire
passes through the slot in the
side of the tank. (Figure 7)
Figure 7
Emitter
Wire Slot
Transducer
9