WEG CFW100 Guía De Instalación, Configuración Y Operación página 4

Table 2: Configuration of the switches to configure the RS485
Comunication Switch Switch Setting
SR
(*) Any other combination of the switches is not allowed.
(**) It is recommended to use this termination with cables longer than 3 m.
NOTE!
The mini USB connector (see figure
„
A.2) is used for communication with the
CFW100-KHMIR kit only.
The use of the mini USB connector for
„
other connections is not permitted.
NOTE!
The use of 38400-bps serial baud rate
(P310=2) with the vector control mode V V W
(P202=5) is not allowed. This condition
activates the Config state (Conf) so as to
indicate parameterization incompatibility.
For further details, refer to chapter 5 of the
CFW100 programming manual.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
S1.1 = OFF and
S1.2 = OFF
(*)
S1
S1.1 = ON and
S1.2 = ON
RS485 Module
Option
RS485
Termination off
RS485
Termination
(**)
on