Precautions - Kenwood NX-3000 Serie Guia Del Usuario

The AMBE+2™ voice coding Technology embodied in this product is protected by intellectual property rights
including patent rights, copyrights and trade secrets of Digital Voice Systems, Inc. This voice coding
Technology is licensed solely for use within this Communications Equipment. The user of this Technology is
explicitly prohibited from attempting to extract, remove, decompile, reverse engineer, or disassemble the
Object Code, or in any other way convert the Object Code into a human-readable form. U.S. Patent Nos.
#8,315,860, #8,595,002, #6,199,037, #6,912,495, #8,200,497, #7,970,606 and #8,359,197
Firmware Copyrights
The title to and ownership of copyrights for firmware embedded in KENWOOD product memories are
reserved for JVC KENWOOD Corporation.
Observe the following precautions to prevent fire, personal injury, and transceiver
damage.
Do not attempt to configure the transceiver while driving; it is too dangerous.
●
Do not disassemble or modify the transceiver for any reason.
●
Do not expose the transceiver to long periods of direct sunlight, nor place it near heating appliances.
●
If an abnormal odor or smoke is detected coming from the transceiver, switch the transceiver power
●
off immediately, and contact your KENWOOD dealer.
Use of the transceiver while you are driving may be against traffic laws. Please check and observe the
●
vehicle regulations in your area.
Do not use options not specified by KENWOOD.
●
Do not put the plastic bag used for packing of this equipment on the place which reaches a small child's
●
hand. It will become a cause of suffocation if it wears flatly.
Do not place the transceiver on unstable surfaces.
●
Keep the volume as low as possible to protect your hearing.
●
Always switch the transceiver power off before installing optional accessories.
●
To dispose of batteries, be sure to comply with the laws and regulations in your country or region.
●
CAUTION
The transceiver operates in 12 V negative ground systems only! Check the battery polarity and
●
voltage of the vehicle before installing the transceiver.
Use only the supplied DC power cable or a KENWOOD optional DC power cable.
●
Do not cut and/or remove the fuse holder on the DC power cable.
●
Do not place the microphone cable around your neck while near machinery that may catch the
●
cable.
WARNING
For passenger safety, install the transceiver securely using the supplied or optional mounting
●
bracket and screw set so the transceiver will not break loose in the event of a collision.
When using the transceiver, refer to the "NOTICES TO THE USER" and "PRECAUTIONS". If the
warnings are not observed, there may be possibility of malfunction. In this case, press and hold the Power
Switch for 5 seconds or more. If the malfunction persists, ask your dealer.
4

PRECAUTIONS