Klein Tools ET310 Manual De Instrucciones página 5

Detector digital de cortacircuitos
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
MAINTENANCE
BATTERY REPLACEMENT
When the Power-On indicator
1. Open the battery compartment door
locking screw.
2. Remove exhausted 9V battery and dispose of appropriately.
Remove exhausted 9V battery and dispose of appropriately.
3. Replace the 9V battery, close the battery door, and re-fasten the
Replace the 9V battery, close the battery door, and re-fasten the
locking screw.
Be sure unit is turned off and wipe with a clean, dry lint-free cloth.
Do not use abrasive cleaners or solvents. Take care to keep the
sensor lens clean at all times. If required, loose debris may be
removed from lens using clean compressed air. Lens may also be
cleaned using a soft cloth or cotton swab with water or rubbing
alcohol only. Lens must be allowed to completely dry prior to use.
The transmitter
may be docked in the transmitter receptacle
1
in the receiver
for convenient storage. Remove the batteries when
2
the tester will not be used for a prolonged period of time. Do not
expose to high temperatures or humidity. After a period of storage
in extreme conditions exceeding the limits mentioned in the General
Specifications section, allow the tester to return to normal operating
conditions before using.
WARRANTY
www.kleintools.com/warranty
DISPOSAL / RECYCLE
Do not place equipment and its accessories in the trash.
Items must be properly disposed of in accordance with local
regulations. Please see www.epa.gov or www.erecycle.org
for additional information.
CUSTOMER SERVICE
KLEIN TOOLS, INC.
450 Bond Street Lincolnshire, IL 60069 1-877-775-5346
customerservice@kleintools.com www.kleintools.com
8
blinks, the battery must be replaced.
4
by unscrewing the
by unscrewing the
10
CLEANING
STORAGE
ESPAÑOL
MANUAL DE INSTRUCCIONES
Detector digital
de cortacircuitos
• INDICACIONES
VISUALES Y AUDIBLES
VISUALES Y AUDIBLES
QUE IDENTIFICAN
CLARAMENTE EL
CORTACIRCUITOS
CORRECTO
• FUNCIONA EN
90 V-120 V CA
• DETERMINA
CONDICIONES DE
CABLEADO EN
TOMACORRIENTES
• PRUEBA DISPOSITIVOS
PRUEBA DISPOSITIVOS
GFCI
2 m
IP40
11
ET310
5000573

Publicidad

Tabla de contenido
loading

Tabla de contenido