Mounting Instructions - D-Link DCS-4622 Guia De Instalacion

Mounting Instructions

It is highly recommended that you configure and test your camera before
mounting it.
Use a screwdriver to unscrew the tilt adjustment
screw. Pull the mounting plate away from the
camera mount.
Place the mounting plate where you want to
position the camera and use a pencil to mark the
two mounting holes.
If you wish to run the camera cables through
the wall or ceiling, mark the center hole as well.
Use a 6 mm drill bit to make the required holes
approximately 25 mm deep, then insert the wall
anchors into the holes. Use the screws provided to
attach the mounting bracket to the wall.
If you wish to run the camera cables through
the wall or ceiling, drill the center hole for the
camera cables to pass through.
Connect the power and Ethernet cables, or just the
Ethernet cable if you are using a PoE connection.
6
D-Link DCS-4622 Quick Installation Guide