Chevrolet LT1 E-ROD Hoja De Instrucciones página 8

Post-Catalysts (Rear) Oxygen Sensors should be mounted in the provided locations in the catalyst assembly. It is highly recommended that the Oxygen
Sensor bosses in catalyst assemblies be used without modification. If they need to be moved or mounted differently to fit your vehicle, the sensors need
to be mounted the same distance from the rear of the front catalyst's brick/honeycomb as the unmodified catalyst assembly. The oxygen sensors should
be mounted with the sensor tip pointing between 10 degrees above horizontal and fully downward – do not mount with the tip oriented upward.
Modifications to the exhaust system are likely in order to fit your particular vehicle. The provided front catalytic converters, must be mounted between
16" to 20" (as measured along the path of exhaust gas flow) from the closest cylinder head exhaust port face. Rear oxygen sensors should angle toward
the center of the vehicle.
BOTTOM VIEW OF EXHAUST
RIGHT SIDE CATALYTIC
CONVERTER TO CATALYTIC
CONVERTER CONNECTION
2 STUDS
1 FLAT GASKET
2 NUTS
LEFT SIDE CATALYTIC CONVERTER
CONNECTOR CLAMP
LT1 E-ROD Instruction Sheet
ALL INFORMATION WITHIN ABOVE
Date
BORDER TO BE PRINTED EXACTLY
20MY19
AS SHOWN ON 8.5 x 11 WHITE 16
POUND NON-BOND RECYCLABLE
03OC19
PAPER. PRINT ON BOTH SIDES,
EXCLUDING TEMPLATES. TO BE
UNITIZED IN ACCORDANCE WITH
GMCCA SPECIFICATIONS.
TOP VIEW OF EXHAUST
Revision
Init Rel – Blake Nye
Rev – Blake Nye
EXHAUST MANIFOLD TO CATALYTIC
CONVERTER ATTACHMENT
4 STUDS PER SIDE
1 ROUND GASKET PER SIDE
4 NUTS PER SIDE
PART No.
Rev 03OC19
Auth DR
Title
NA
NA
PART No.
19418603
Installation Instructions
LT1 E-ROD
19418603
SHEET
8 of 69
SHEET 8 of 69