Hayward ZKD Serie Manual De Instalación página 8

Display during Operation
Operating mode
•
Timer
Alarms and statuses
•
Liv = level alarm
•
Flow = flow alarm or
....Release wait
Paragraph 3 – Timed Dosage (Frequency signal input "TRIGGER" not activated)
Programming
PROG
Configuration
Configuration
Pum functions
-
+
Pum functions
Tempo
-
Time
+
-
Quantity 100ml
-
Time g.hh.mm
+
-
Delay 0.01.50
-
Time g.hh.mm
+
-
Interval 0.01.50
-
Trigger Mode
+
-
Disable
Pause Input Mode Pause Input Mode
Restart Timer
Restart Timer
-
Pause Input Mode
Freeze Time
Pause Input Mode
Pause Dosing
-
Relay
-
Off
Hayward Flow Control
FLOW
Programmed value
sensor status
•
Quantity in ml
Timer F F F 7,0 ml
Stop P 0%
Value of the dosing in
progress
Pump status
•
Dry = pump starting up
•
Stop = pump stop
•
Restart = pump restart
The pump doses a programmed quantity in ml. It is possible to set a
pump delay time (Delay) when the pump is started and an interval
between two successive dosings (Interval), as illustrated in the diagram:
The Delay and Interval times are in dd.hh.mm (days, hours, minutes)
The Pause input can be programmed in three different modes:
1. FreezeTime: when the pause is activated, the system cuts out
2. Pause Dosing: with the pause activated, the system continues
3. Restart Timer: when the pause is activated, the system stops
-
During the operation of the pump, it's possible to change the dosing
-
frequency by simultaneously pressing
frequency or the
+
The values of the relay connected to dosage can be modified using the
the relay is not switched off (open), and in "after" mode the relay closes
when dosage is activated and remains closed once dosage is completed
for the time (in seconds) set using the
www.haywardflowcontrol.com
key; in "Off" mode, the relay is not switched off (open), and in
"after" mode the relay closes when dosage is activated and
remains closed once dosage is completed for the time (in
seconds) set using the
pressing the key. In "before" mode, the relay closes before
the dosage activation time, for the time (in seconds) set using
the keys and then confirmed by pressing the
key.
•
Q.tà
•
Percentage of
strokes/min
max
Value of the dosing percentage,
which can be modified by
pressing the + or – keys
Operation
Quantity
Delay
Interv.
the current time count and restarts it when the pause is
deactivated.
to count time the and stops the dosing.
the dosing and when the pause is deactivated the count starts
again from the beginning.
keys to decrease it.
keys and confirmed by pressing the
keys and then confirmed by
Display during Setting (MODE key)
Operating mode
The following are shown in sequence:
quantity to dose, delay in d.hh.mm.
and interval in d.hh.mm
•
20,0ml
20,0ml P 100%
keys to increase the
key; in "Off" mode,
keys and then confirmed
1-888-INDL (1-888-429-4635)
Dosing value
Programmed
quantity in m
l
ZKDIOM
Pg. 6 of 10