Emptying The Tank - Rowenta DH4110 Guia Del Usuario

EN
Your appliance is programmed for continuous start-up but, at your convenience, you can also select:
– The speed (button C)
– The target humidity rate (button B)
And on models DU4116/DH4120/DU4120 and DH4130/DU4130:
– The drying clothes function (button D)
– The Swing function (button E)
The indicator light (G) will be lit up awaiting automatic operation of the appliance.
PLEASE NOTE: the appliance will regulate itself automatically to maintain the target humidity rate
during the period of operation.
If you wish to exit the program, select "00 H" or start the appliance with button A; the light will switch off.
• DRY Function for Drying clothes (Mod DU4116/DH4120/DU4120 & DH4130/
DU4130)
Press the DRY (D) button to start the clothes drying function.
Continuous dehumidification and swing of the air outlet vent will start up automatically for en-
hanced clothes drying.
• SWING Function (Mod DU4116/DH4120/DU4120 & DH4130/DU4130)
Press the "SWING" button (E): the air outlet vent will automatically swing, providing enhanced dis-
tribution of dry air around the room.
• DEFROSTING INDICATOR LIGHT
If light (I) comes on, the dehumidifier is in defrosting mode. The compressor shuts down and will
start up again automatically after the defrosting phase.
NOTE: Check that the pre-filter is clean.
• FULL indicator light
The appliance beeps and the indicator (H) flashes when the tank is full or incorrectly positioned. The
indicator stops flashing and the dehumidifier starts up again once the tank is emptied and replaced.
• FILTER
It is essential to switch off your appliance using button (A) and to unplug it before any operation.
– Your appliance is fitted with a removable cleanable pre-filter/nano which must be cleaned regularly.
– Remove the pre-filter/nano (Fig.3 - Safety instructions) and clean it with a vacuum cleaner.
– Re-fit the pre-filter/nano (Fig.4-5 - Safety instructions).
– Never use the appliance without its pre-filter/nano.

• EMPTYING THE TANK

It is essential to switch off your appliance using button (A) and to unplug it before any operation.
When the tank is full:
– The appliance shuts down and the red FULL indicator light (H) comes on
– Remove the tank gently from the appliance (Fig.6 - Safety instructions), empty the water and put
the tank back into the appliance.
The red FULL indicator light (H) should switch off in a few seconds.
• CONTINUOUS DRAINAGE (see Fig 7 - Safety instructions).
It is essential to switch off your appliance using button (A) and to unplug it before any operation.
Use a PVC pipe, 12 mm in diameter (the 12mm diameter is the internal diameter of the hose).
– Remove the plug (13) then connect the pipe to the drainage outlet.
– Ensure that the slope between the 2 ends of the pipe allows water to flow away normally.
13