Maintenance - Husky H38CPRAT Guía De Uso Y Cuidado

Operation
6
Using the LED worklight
□ When the tool is switched on, the LED worklight (E)
also comes on to ensure better vision and to make
working in dark areas safer.
8
Loosening bolts and nuts
□ Install the correct socket to match the bolt or nut.
□ Apply just enough pressure to keep the socket
engaged on the bolt or nut.
□ Position the forward/reverse lever (B) in the correct
position for reverse rotation.
□ Initially apply minimal pressure to the paddle switch
(C). Increase the speed only when full control can be
maintained.
NOTE: If the bolt or nut is too tight
to release when the paddle switch
is pressed at the beginning, you
can try to loosen the bolt or nut
manually rst, and then press the
paddle switch.

Maintenance

Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from
various types of commercial solvents and may be
damaged by their use. Use clean clothes to remove
dirt, dust, oil, grease, etc. Keep tool handles clean,
dry and free of oil or grease.
WARNING:
personal injury and damage, never
immerse your tool or charger in liquid
or allow a liquid to ow inside them.
Reduce the risk of
7
Tightening bolts and nuts
□ Install the correct socket to match the bolt or nut.
□ Apply just enough pressure to keep the socket
engaged on the bolt or nut.
□ Position the forward/reverse lever (B) in the correct
position for forward rotation.
□ Initially apply minimal pressure to the paddle switch
(C). Increase the speed only when full control can be
maintained.
9
Storing the ratchet
□ Do not expose your tool and charger to water or rain,
this could cause damage.
□ Fully charge the tool before placing it in storage. For
optimum life, store the tool at room temperature away
from moisture. Permanent capacity loss can result if
tool is stored for a long period at high temperature.
Every six months of storage, fully charge the tool.
WARNING:
injury, always unplug the charger and
lock the paddle switch before cleaning
or performing any maintenance.
Never disassemble the tool or charger.
Contact a service facility for all repairs.
When servicing, use only identical
replacement parts. The use of any
other parts may create a hazard or
cause damage to the product.
11
l P a e e s c n o a t t c
To avoid serious personal
HUSKYTOOLS.COM
- 1 8 8 - 8 D H H - U K S f Y r o u f t r e h a r s s s i a t c n . e