Operation - Husky H38CPRAT Guía De Uso Y Cuidado

Operation

1
Charging the ratchet
□ Turn off the lock button (D).
□ Connect charger (G) to the tool. Align the raised
portion on the charger connector with the groove on
the charging inlet of the tool and insert it in position.
□ Plug into an appropriate outlet.
□ During the charging process, the charging lights will
indicate the charging status as follows:
- Less than 30% charged: all three charging lights
will blink in sequence.
- Less than 60% charged: one light will stay on,
while the other two lights will blink in sequence.
- Over 60% charged: two lights will stay on, while
the remaining light will blink continuously.
- Fully charged: all three lights will remain on
continuously.
□ The charging process will be last approximately 70
minutes and permanent lighting of all three charging
lights (F) will indicate charging is complete.
Remaining power indicator (F)
If the paddle switch is pressed, the remaining power
indicator (F) lights and the battery's remaining power
can be checked.
3 LEDs light up: >60%
2 LEDs light up: 30%-60%
1 LED lights up: <30% Charging of the rechargeable
ratchet is required
2
Installing and removing a socket
□ Make sure that the lock button (D) is turned off.
□ To install a socket, slide it onto the anvil (A) of the
tool and simply push it until it locks in place.
□ To remove a socket, pull it off the anvil (A).
CAUTION:
are recommended for this ratchet.
Inspect sockets prior to use to ensure
that they have no cracks or other
visible damage.
Use only accessories that
G
A
9
l P a e e s c n o a t
F
HUSKYTOOLS.COM
t c - 1 8 8 - 8 D H H - U K S f Y r o u f t r e h a r s s s i a t c n . e