Typical Applications - Alesis NANOVERB 2 Guia De Inicio Rapido

POWERING UP
Before turning on the NANOVERB 2's power, check the following items:
•
Ensure all cable connections have been made correctly
•
Ensure the volume controls of your amplifier or mixer are turned down
•
Insert the Power jack into the [POWER] input on the rear panel of the NANOVERB 2 and plug the power adapter
into an AC outlet
•
Then power-up the NANOVERB 2, the Power On LED will illuminate
•
Turn on the power of the amplifier/mixer, and adjust the volume
SETUP
When connecting audio cables and/or turning the NANOVERB 2 on and off, make sure all connected devices have
their volume controls turned down.

Typical Applications

The audio inputs and outputs of the NANOVERB 2 are typically used in one of three ways:
1) From one or two effect/aux send outputs of a mixer, sent back to the effect return inputs of the mixer
2) From a line-level instrument (like a guitar or keyboard with either a mono or stereo output), sent out to an
amplifier or mixer input
3) From the stereo bus outputs of a mixer to a recorder or amplifier
MONO- Connect an audio cable from the output of a mono source or Aux Send to the LEFT input of the NANOVERB
2 and then connect another audio cable from the LEFT output of the NANOVERB 2 to the input of a mixer, amplifier,
or Aux Return.
MONO IN, STEREO OUT- Connect a mono output source or Aux Send to the LEFT input of the NANOVERB 2. Then
connect two audio cables from the LEFT and RIGHT outputs of the NANOVERB 2 to the inputs of your mixer,
amplifier, or Aux Return.
STEREO- Connect audio cables from the output of a stereo source or Aux Send to the LEFT and RIGHT inputs of the
NANOVERB 2. Then connect the LEFT and RIGHT outputs of the NANOVERB 2 to the stereo inputs of a mixer,
amplifier, or Aux Return.
SETTING MIXER AUX SEND/RETURN LEVELS
1. First set your mixer's input levels appropriately, following the instructions for the mixer.
2. Turn up the mixer channels AUX SEND to a nominal level (this is usually between "noon" and "3:00" on a rotary
knob).
3. Play the audio source.
4. Turn up the NANOVERB 2's [INPUT] level until you see the [SIGNAL] LED turn red on peaks; then reduce it
slightly until the LED doesn't flash.
5. Depending on the input sensitivity of the mixer's channels or Aux Returns, the [OUTPUT] knob of the
NANOVERB 2 should be set between "2:00" and fully clockwise ("5:00").
6. Turn up the AUX RETURN level until you get the desired level of effect in the mix. If you want "just a hint" of
reverb, turn down the Aux Return. Leave the input levels where they were set in step 4, unless you see the
[SIGNAL] LED flash.
4