Dometic PR2000 Instrucciones De Montaje página 19

PR2000, PR2500
8. Extend the other strut in the same way.
9. Turn the hand crank until the awning is extended to the required position.
Position the struts vertically and back under the front panel every 30 cm so that
the awning stays secured at all times.
10. Turn the hand crank approx. a quarter of the way back to tighten the fabric.
A
NOTICE! Beware of damage.
The fabric of the awning should not hang down at the edges, and must
remain taut at all times. If the fabric hangs down, it could rub against the
arms and become damaged.
The fabric used for long awnings should not sag in the middle.
11. Remove the hand crank from the holder on the awning.
Extending the motor version
!
WARNING! Beware of injury.
Keep a sufficient distance from objects or other vehicles. Once it is
retracted, it should be at least 40 cm away from other objects and
vehicles on all sides.
I
NOTE
Only for operation with the remote control:
• When the vehicle is started, the awning retracts automatically. While
the vehicle is running, the awning is blocked and can not be
extended.
• The receiver beeps once when it is switched on.
• Operation of the remote control can be affected by interference if
another device is being used nearby on the same frequency.
• Keep the remote control in a safe place while you are driving. The
magnet in the holder is not designed for strong vibrations, such as
sudden braking.
1. Press the button
extended by about 1.5 metres (fig. 4, page 4).
2. Push the right strut in the front cover together so that you can move it freely
(fig. 5, page 5).
3. Turn the right strut to the side (fig. 5, page 5).
4. Fold the right strut down and set it on the ground (fig. 6, page 6).
5. Adjust the strut to the required height (fig. 7, page 6).
EN
of the switch or the remote control until the awning is
Operating the awning
19