Installation
AV30
WARNING
Make sure that all water supply lines have been flushed and then completely turned off before beginning
installation. Debris in supply lines can cause valves to malfunction.
Turn OFF electrical power to the electrical outlets, then unplug all electrical units prior to installation. Electrical
power MUST remain off until installation is complete. After installation is complete, turn on the water supply
first, then turn on the electrical power.
Installer's hardware must be appropriate for wall construction. Wall anchors must have a minimum pull-out
rating of 1,000 pounds.
IMPORTANT
Read this entire installation manual to ensure proper installation. When finished with the installation, file this
manual with the owner or maintenance department. Compliance and conformity to local codes and ordinances
is the responsibility of the installer. Product warranties may be found under "Products" on our website at
www.bradleycorp.com.
Separate parts from packaging and make sure all parts are accounted for before discarding any packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
WARNING!
To Reduce The Risk Of Fire Or Electric Shock, DO NOT
Use This Fan With Any Solid-State Speed Control Device!!
NOTICE
With supervision or instruction, this device may be used by
preschool aged children and persons with special needs.
This is not a toy. Cleaning and maintenance shall only
be performed by qualified personnel.
Bradley • 215-1771 Rev. H; ECN 16-08-027
5/10/2017
3