Dyson Airblade 1 Guia De Instalacion página 16

If connecting to cold only water feed you will
need to install a heater.
The water supply to this product must be
fitted with a temperature control device in
accordance with local regulations.
A= Thermostatic mixing valve
B= Hot and cold feed
C= Desired temperature out
AU
D= Isolation valve
NZ E= Heater
F= Cold feed in
Additional
Information
Installing
Do not use sealant when fixing the unit to
the wall.
Ensure electricity and mixed water supplies
and drainage connections are available for
connection. Suitable isolation of the power
and water supplies must be in place to switch
off supplies before install and for servicing.
Electrical
Input voltage/Frequency: Refer to
rating plate.
Isolated by switch fuse spur or RCD
as appropriate.
Current 6.6 A.
Cable specification: Dual core PVC + Single
core PVC (earth)
Local electrical regulations must be adhered
to when installing or repairing the product.
Rated power: Refer to rating plate.
Operating temperature range: 0° – 40°C.
Standby power consumption:
Less than 0.5 W.
Maximum altitude: 2,000 metres.
16
Water operation
Water flow rate: 4 l/min normal fitted aerator.
1.9 l/m with low flow aerator supplied
with product.
Water pressure required: 1-8 bar. 1⁄2" BSP
isolated valve required for service.
Keep secondary hot water return as close
to thermostatic mixing valve as possible to
reduce the risk of Legionella bacteria growth.
Automatic duty flush
The unit is equipped with a fixed automatic
water flush, which activates for 60 seconds
24 hours after last use. This helps reduce
water stagnation and bacteria proliferation
within the product.
Please ensure the unit is always installed
over a functional basin with free and
connected drainage.
Water supply cleanliness and
biological growth
In some countries there are regulations
or guidelines that require temperature
controlled water supply systems (such as that
supplied to the Dyson Airblade Wash+Dry
hand dryer) to be subjected to regular
cleaning to minimise any biological growth.
To enable you to meet these regulations,
the Dyson Airblade Wash+Dry hand dryer
has been designed and tested to withstand
internal cleaning both with hot water up
to 95°C and with sodium hypochlorite at a
concentration of 0.45%.
Please refer to specific (market) regulations
and water supply system recommendations
for information on cleaning regimes for water
supply cleanliness and biological growth for
your country.
When carrying out internal cleaning of the
Dyson Airblade Wash+Dry hand dryer,
please be aware of any safety considerations
when using hot water or chemicals. Dyson
will not be responsible for any injury caused
by this process.
Abusive testing
The Dyson Airblade Wash+Dry hand dryer
has undergone rigorous abusive testing to
ensure that it can withstand substantial forces
and impacts typical of a commercial and
public bathroom environment.