Dyson Airblade 1 Guia De Instalacion página 303

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 310
IMPORTANT SAFETY
INSTRUCTIONS
READ AND SAVE
THESE INSTRUCTIONS
BEFORE INSTALLING OR USING THIS UNIT READ ALL
INSTRUCTIONS AND CAUTIONARY MARKINGS IN THIS
INSTALLATION GUIDE AND THE OWNERS MANUAL.
WARNING
ALL INSTALLATION AND REPAIR WORK (PLUMBING AND
ELECTRICAL) SHOULD BE CARRIED OUT BY A QUALIFIED PERSON
OR DYSON SERVICE TECHNICIAN IN ACCORDANCE WITH
CURRENT LOCAL CODES OR REGULATIONS.
WARNING
RISK OF ELECTRIC SHOCK!
IF CASING IS REMOVED OR HANDLED IMPROPERLY THE INTERNAL
COMPONENTS OF THE UNIT MAY CAUSE HARM OR BECOME
PERMANENTLY DAMAGED.
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
Before beginning any installation work you must confirm the following.
• Check that the electrical supply corresponds to that shown on the
rating plate.
• A means for all-pole disconnection must be incorporated into fixed
wiring, in accordance with local wiring regulations.
• Connect the electricity supply using suitable conduit and electrical
fittings. Ensure that the conduit and wires are long enough to connect
to the backplate and the terminal block. Solid metal conduit is not
suitable for side entry.
WARNING
Use caution when unpacking the components. There may be sharp
edges/corners which may cut or cause harm.
DO NOT USE ANY JET WASH EQUIPMENT FOR CLEANING ON OR
NEAR THIS UNIT
US
USES
AR
CL
GT
MX
PA
303

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Airblade 1aAirblade wash+dry 1a

Tabla de contenido