Setting Preset Eq; Switching The Sound Adjustment Mode; Parametric Equalizer Adjustment (Peq); Adjusting Center Frequencies And Q Curves - Fujitsu Ten ECLIPSE CD3100 Manual Del Propietário

Various Settings

Setting preset EQ

Press the [EQ/MENU] button to
1
select the preset EQ.
Preset EQ modes are switched in the
order shown below each time the
button is pressed.
Mode
DEFEAT
POWER Low frequencies emphasized
SHARP High frequencies emphasized
VOCAL Mid frequencies emphasized
CUSTOM
ATTENTION
When BASS, MIDDLE and TREBLE values
are adjusted in audio control mode, CUSTOM
EQ will be updated. (Refer to page 38 for
details on audio control operation.)
Switching the Sound
Adjustment Mode
Press the [EQ/MENU] button for
1
more than one second.
The Menu Selection mode is activated.
Press the [SELECT] (Upper/Lower)
2
button to select the SOUND.
3
Press the [ENTER] button.
The sound
activated.
Press the [SELECT] (Upper/Lower)
4
button to select the setting item.
When the button is pressed, the
setting item changes as follows.
PEQ ↔ X-OVER FR ↔ X-OVER NF ↔
NON-FADER ↔ PEQ ↔
5
Press the [ENTER] button.
Switches among the adjustment modes.
42
Description
FLAT
Equalizer user preset value
adjustment mode
ATTENTION
If returning to previous screen, press the [RTN]
button.
Parametric equalizer
adjustment (PEQ)
Press the [SELECT] (Upper/Lower)
1
button to select the PEQ.
2
Press the [ENTER] button.
The PEQ setting mode is activated.
Adjusting center frequencies
and Q curves
The three bands, Bass, Middle and Treble can be
adjusted and each band has frequency level and
Q curve to be adjusted. Narrow, Normal, MidWide
and Wide can be adjusted for Bass, Normal and
Narrow for Middle, and Normal for Treble.
Press the [ENTER] button to select
1
the band to be adjusted.
Each time the button is pressed, the
band changes in the following order.
BASS → MIDDLE → TREBLE →
Press the [SELECT] (Upper/Lower)
2
button to adjust the Q curve
pattern.
Each time the button is pressed, the Q
curve pattern changes as follows.
is
When the BASS is selected:
WIDE ↔ MidWIDE ↔ NORMAL ↔
NARROW
When the MIDDLE is selected:
NORMAL ↔ WIDE
When the TREBLE is selected:
NORMAL (FIX)
WIDE MidWIDE NORMAL NARROW