Plus U3-1080 Manual Del Usuario página 26

M a n u a l
C o m p u t e r
Adjusting Clock Frequency and Phase
1
Select RGB as the input (page 16).
2
Press the MENU button to display the
main menu and then press the cursor
keys to select the "IMAGE".
3
Press the cursor
"PICTURE ADJ".
4
Press the cursor
the image width in relation to the screen.
Adjustment is performed in dot units. Adjust to
the position where vertical flicker disappears.
5
Press the cursor
"FINE PICTURE".
6
Press the cursor
minimize image noise, flicker, color varia-
tions, etc.
Reconnecting a separate personal computer or
other device to the RGB jack
Either press the AUTO button on the main unit or open the FLIP
COVER of the remote control and press the AUTO button there.
If no images appear during setting
Use the following procedure when no images appear during setting
because the clock frequency or phase is grossly inaccurate.
1 Turn off the power of all devices connected.
The input signal will stop and either a blue or black background
(This depends on the Background setting. page 28) will be
projected.
2 Perform a reset (page 25).
3 Readjust the picture ADJ and fine picture
A d j u s t m e n t
I m a g e s
/ keys to select the
/ keys and adjust
/ keys and select
/ keys and adjust to
http://www.pureglare.com.au
o f P e r s o n a l
Adjusting the position of the image
If the image is offset up, down, left or right, adjust the
vertical and horizontal position.
1
Perform steps 1 - 6 for Adjusting the
/
Clock Frequency and Phase on this page.
2
Press the cursor
"POSITION".
3
Press the cursor
adjust the horizontal and vertical posi-
tion.
E – 24
/ keys and select
/ , / keys and
To close the menu
Press the CANCEL button.