Using The Power Saving Function - Plus U3-1080 Manual Del Usuario

Auto Source Settings
Automatically Searching The Input Signal
1
With the FLIP COVER of the remote con-
trol open, press the MENU button to dis-
play the Advanced menu, then use the
cursor / keys to select "SETUP".
2
Use the cursor
SOURCE", then use the cursor
keys to set ON or OFF.
ON: All input signals are searched.
OFF: Remote control VIDEO button:
Video and S-video are searched.
Remote control RGB button:
RGB and YCbCr signals are searched.
Main unit SOURCE button:
All input signals are searched individually.
Selecting a Projection Type
If the projection type is not correctly set in accordance with the
installation conditions, images may be projected reversed, verti-
cally, or horizontally.
1
With the FLIP COVER of the remote con-
trol open, press the MENU button to dis-
play the Advanced menu, then use the
cursor / keys to select "SETUP".
2
When SETUP menu is displayed, use the
cursor / keys to select "PROJEC-
TION", then press the ENTER button.
3
Use the cursor
projection type in accordance with the
set conditions.
The setting items will change as shown below
each time a key is pressed.
⇔
Normal
Reversed vertically ⇔ Reversed horizontally
/ keys to select "AUTO
/
/ keys to select a
Reversed vertically+horizontally
http://www.pureglare.com.au

Using the Power Saving Function

When there is no signal input for a period of 5 min. or
more, the power is automatically turned off and standby
status is activated.
1
With the FLIP COVER of the remote con-
trol open, press the MENU button to dis-
play the Advanced menu, then use the
cursor /
2
When SETUP menu is displayed, use the
cursor
POWER OFF".
3
Use the cursor
Saving to ON or OFF.
E – 29
buttons to select "SETUP".
/ keys to select "AUTO
/ keys to set Power
To close the menu
Press the CANCEL button.