Assembling Your Chipper Shredder Vacuum - MTD 24A-020D000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING - YOUR RESPONSIBILITY:
understand and follow the warnings and instructions in this manual and on the machine.
NOTE: Not all safety labels shown may apply to your chipper shredder vacuum.
SECTION 2: ASSEMBLING YOUR CHIPPER SHREDDER VACUUM
This unit is shipped without gasoline or oil
IMPORTANT:
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
NOTE: Reference to right or left hand side of the
chipper shredder vacuum is observed from the
operating position.
Removing Unit From Carton
Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton.
Remove loose parts if included with unit (i.e.,
operator's manual, etc.)
Cut along corners, lay carton down flat, and remove
packing material.
Roll or slide unit out of carton and check carton
thoroughly for loose parts.
Loose Parts In Carton
Handle Assembly
Bag
Blower Chute (If Equipped)
Disconnecting Spark Plug Wire
Before setting up your chipper shredder vacuum,
disconnect the spark plug wire from the spark plug and
ground to a stud on the engine.
(See Figure 1)
Restrict the use of this power machine to persons who read,
Blower Chute
Wing
Nuts
Lower
Handle
Wing
Nuts
Carriage
Screw
5
Upper
Handle
Figure 1
Bag

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido