Maintaining Your Chipper Shredder Vacuum; Customer Responsibilities - MTD 24A-020D000 Manual De Instrucciones

vines until they are thoroughly dried out. Materials such
as stalks or heavy branches up to 1 1/2" in diameter
may be fed into the chipper chute. See Figure 7.
Chipper
Chute
Figure 7
The flail screen is located inside the
IMPORTANT:
housing in the discharge area. If the flail screen
becomes clogged, remove and clean as instructed in
SECTION 5: MAINTAINING YOUR CHIPPER
SHREDDER VACUUM. For best performance, it is also
important to keep the chipper blade sharp.
SECTION 5: MAINTAINING YOUR CHIPPER SHREDDER VACUUM

Customer Responsibilities

MAINTENANCE
SCHEDULE
Lubricate Wheels
Lubricate Nozzle Levers
Lubricate Locking Rod
Check Chipper Blade
Change Oil
Check Air Filter
Clean Engine
Check Spark Plug
WARNING: Do not at any time make any
adjustments without first stopping engine
and disconnecting spark plug wire.
Nozzle Height Adjustment
The nozzle can be adjusted to any five positions,
ranging from 5/8" to 4 1/8" ground clearance. The
nozzle height has to be adjusted according to the
conditions. Move the height adjustment levers forward
or backward to adjust the nozzle upwards or
downwards. See Figure 8.
NOTE: In general, raise the nozzle height to vacuum a
thick layer of leaves or to operate with the blower chute
Nozzle
and lower the nozzle height for smoother surfaces.
Nozzle
9
Nozzle Height
Adjustment
Lever
Figure 8
SERVICE
DATES