Commissioning; Battery Installation; Setting The General Parameters Of The Remote Control Transmitter - SOMFY Telis 6 Chronis RTS Manual Del Usuario

5. Commissioning

Before using the Telis 6 Chronis RTS, we recommend that each motor is programmed in advance
using an individual Telis 1 RTS type control point and that the limit switches of each motor are set.
However, like any RTS remote control transmitter, the Telis 6 Chronis RTS can be used for motor
commissioning operations (limit switch adjustment, etc.).
This manual only describes commissioning using an individual RTS control point such as Telis 1 RTS.
For commissioning with a different RTS control point, refer to the corresponding manual.
After 2 minutes of inactivity, the Telis 6 Chronis RTS screen switches automatically to sleep mode.
When the screen is off, first press any button to turn it on.
When editing the settings, you can return to the operating mode (manual or automatic) at any time
by pressing and holding the selection button ( ). Only confirmed parameters are saved.

5.1. Battery installation

- Remove the battery cover from the back of the Telis 6
Chronis RTS.
- Insert the 2 AAA (LR3) batteries following the polarity
indicated.
- Replace the battery cover on the Telis 6 Chronis RTS.
- Activate the Telis 6 Chronis RTS by pressing any button.
Never use rechargeable batteries.
Replace the batteries when the ( ) symbol appears on
the screen.
If there is no power supply for an extended period of time (batteries out of charge or removed), the
general parameters of the remote control transmitter will have to be reset. However, automatic
orders remain stored in the memory.

5.2. Setting the general parameters of the remote control transmitter

When the batteries are first installed, "Remote control settings" mode is activated directly: "SET" and
"YEAR" appear on the screen, with the year flashing (this is the first parameter to be set).
After an extended period of time with no power supply, when automatic mode is selected, "Remote
control settings" mode is also activated directly.
At each stage, the parameter to be set flashes.
- Press the arrow buttons (
the parameter (pressing and holding the
button scrolls the characters faster).
- To save the parameter and move to the
next parameter, briefly press the selection
button ( ).
- "Remote control settings" mode can be
deactivated at any time by pressing and
holding the selection button ( ). Only
confirmed parameters are saved.
Copyright © 2010 Somfy SAS. All rights reserved.
or ) to change
Telis 6 Chronis RTS
2 x LR03
AAA 1.5 V
2 s
3