Part Description - Telcoma Automations T400 Manual De Instrucciones

GB

PART DESCRIPTION

4
3
2
1
Fig. 1 / Abb. 1
1) Motor connection terminal board
2) STOP/PROG Pushbutton for Programming and Stop*.
3) 230V or 400V mains voltage input terminal board
4) 3 x 6 A power fuses
5) Transformer
6) Terminal board for power supply voltage selection
7) 250mA 250V secondary transformer fuse
8) 24 V 0.3 A fuse
9) Control and safety device input connection terminal board
10) Trimmer for encoder sensitivity setting
11) Indicators LEDs for terminal board inputs. LED on = input closed
12) Function dip-switch
13) Programming LED (L1)
14) Connector for SR series receiver
15) ECU reset. Shorting the 2 pins for a moment has the
same effect as switching power off then on again.
16) Jumper for selection of OC2 receiver outputs
5
6 7 8 9
24 23 22 21 20
17) Connector for OC2 series receiver
18) TEST Jumper on FT TX output (Photocell TX power supply)
19) Terminal board for low tension connections (24V)
20) Jumper for selection of sensitive edge input selection
21) Terminal board for connection of sensitive edges and
"slave" control unit synchronisation.
22) Encoder connection terminal board
23) Terminal board for connection of US1 contact
10 11
12
13
14
15
16
17
18
19
41