Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
FULL opening programming: Typology 2
MOTOR WITHOUT ELECTRIC LIMIT SWITCHES AND ENCODER
1
9
1)
Shut off power supply to control unit.
2)
Position the gate or door at mid-travel.
3)
Press PROG/STOP button.
seconds.Programming LED L1 comes on. The same function can be obtained by holding the PROG./STOP
STOP button when LED L1 comes on.
backwards, cut off the power, invert the motor phases and the limit switches and repeat the procedure.
8,9) Once the end stop is reached, press the P/P button; the motor stops and then the opening stroke starts
automatically.
10)
Once the opening stroke is complete, press the P/P button. The motor stops.
11)
The control unit starts the pause time registration phase.
12)
Once the desired pause time has lapsed, press the P/P button. The motor then starts the closing manoeuvre.
13)
Once the closing stroke is complete, press the P/P button to stop the motor.
14)
End of programming, LED 1 switches off.
PEDESTRIAN opening programming: Typology 1
AUTOMATION WITH ELECTRIC LIMIT SWITCHES
1)
Shut off power supply to control unit.
2)
Position the gate or door at mid-travel.
3)
Press PROG/STOP button.
seconds. Programming LED L1 comes on.The same function can be obtained by holding the PROG./STOP
48
2
3
10
11
2
1
7
8
PED
4
5
13
12
3
4
9
10
PED
6
7
14
5
6
12
11
8
Publicidad
Tabla de contenido
