Expedition Pro Xpl200 - Samson EXPEDITION PRO XPL100 Manual Del Usurio

Expedition Pro XPL200

5
0 10
VOLUME
MAIN BATTERY
+3dB 75%
0dB 50%
-10dB 25%
LIMITER FUSE: T5AL 250V
CAUTION:
FOR CONTINUED
PROTECTION
AGAINST RISK
OF FIRE,
REPLACE ONLY
WITH SAME
TYPE OF FUSE.
ATTENTION:
AMPLIFIED SPEAKER CABINET
UTILISER UN FUSIBLE
BI-AMPED 150 WATTS LOW AC IN
DE RECHANGE DE
50 WATTS HIGH FREQUENCY
MEME TYPE.
SIGNAL OUTPUT
SIGNAL INPUT AC OUT
POWER
350VA MAX
AC
ON
CHARGE
BATTERY OPERATION
OFF
POWER
100-240 V ~ 50Hz/60Hz 360W
RATING
AVIS;
CAUTION RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE.
RISK OF ELECTRIC SHOCK
DO NOT OPEN MADE IN CHINA
Guided Tour
1: Input connector - Use this balanced female XLR connector to route line-level
signal into the XPL200.
2: Output VU meter - This three-segment bar meter shows the XPL200 output
level. For optimum signal-to-noise ratio, set the Volume control (see #6 below)
so that program material is usually at or around 0 VU, with occasional but not
steady excursions to the red "+3 dB" segment.
3: Power switch - Use this to turn power to the XPL200 on or off.
4: Battery VU meter - If an optional RB 2030 rechargable battery pack is
installed, this meter shows how much battery power remains as it is being
charged (Power switch off ) or depleted (Power switch on).
5: Volume control - This knob sets the level of the XPL200's built-in power
amplifier.
6: Output connector- This balanced male XLR connector carries line-level out-
put signal from the XPL200. It is used to send signal to a second XPL200 being
daisy-chained (see interconnection diagram on the following page) or to an
optional DB1500 subwoofer.
7: AC input - Connect the supplied heavy-gauge 3-pin "IEC" power cable here.
Interconnecting the XPL200
Using one XPL200: A single mono signal (bus or aux send) is
routed from a mixer to the XPL200 XLR input.
5
0 10
VOLUME
MAIN BATTERY
+3dB 75%
0dB 50%
-10dB 25%
LIMITER FUSE: T5AL 250V
CAUTION:
FOR CONTINUED
PROTECTION
AGAINST RISK
OF FIRE,
REPLACE ONLY
WITH SAME
TYPE OF FUSE.
AMPLIFIED SPEAKER CABINET ATTENTION:
BI-AMPED 150 WATTS LOW UTILISER UN FUSIBLE AC IN
DE RECHANGE DE
50 WATTS HIGH FREQUENCY MEME TYPE.
SIGNAL INPUT SIGNAL OUTPUT POWER AC OUT
AC 350VA MAX
ON
CHARGE
BATTERY OPERATION
OFF
POWER 100-240 V ~ 50Hz/60Hz 360W
RATING
AVIS;
CAUTION RISQUE DE CHOC ELECTRIQUE
DO NOT EXPOSE THIS EQUIPMENT NE PAS OUVRIR
RISK OF ELECTRIC SHOCK TO RAIN OR MOISTURE.
DO NOT OPEN MADE IN CHINA
6
SAMSON
MMPL2242
MPL2242
MPL2242