Publicidad
STACKING KIT
If you are not Stacking and/or Ganging Cartesian or Profiles, you may skip this step and continue to assembling the glass
drawer front on page 15.
If you purchased the optional side kits, continue to page 13. For the optional Alcove Kit continue to page 12.
Assemble frames on a clean level surface BEFORE installing on the wall.
Stacking is only available on vanities with the same width.
Place the one Cartesian vanity on top of another. Install 4 screws (SS268) and 4 washers (203-1390) into the holes closest to
the front and back edge. Using the 4 nuts (203-1317) tighten the assembly until firmly secure.
© 2016 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
10
(4) 10-32 Screw
[203-1390]
(4) #10 Washer
[203-1317]
(4) 10-32 Nut
Part no. 209-1232-E-Cartesian, Profiles H2 rev. 05/16/18
Cartesian™ Vanity, Profiles™ Vanity
[SS268]
Publicidad
Capítulos
