Publicidad
ADJUSTING DRAWER FRONTS
Note: Proper installation is very important for proper drawer front alignment on Robern vanities. Making sure the vanity is level and
square in all directions is very important.
1. Loosen the drawer front mounting screws (refer to page 15) to make rough adjustments. Adjust the front both vertically and
horizontally. Once aligned, tighten the screws. When working with multiple drawers, do this step on all drawer fronts before proceeding.
2. Fine adjustments can be done with the adjustment features incorporated in the locking clips. Height adjustment of the drawer front is
done with the slider. Each side may be adjusted independently.
3. Fine adjustment of left to right adjustment can be done. It is recommended to adjust both wheels in the same direction by equal
amounts.
2
DRAWER REMOVAL
1. If a drawer needs to be removed, no tools are required. Look at the image of the drawer clips below. This view is looking up at the
bottom of the drawer.
2. Reaching under each side of the drawer, pull the levers on the locking devices to disengage the clips, and pull out the drawer.
! Caution: You will now be carrying the weight of the drawer!
3. Place the drawer in a safe location so no damage occurs.
© 2016 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Instructions d'installation / Instrucciones de instalación
3
No. de pièce / Pieza n.° 209-1232-E-Cartesian, Profiles H2 rev. 05/16/18
Meuble-lavabo Cartesian™, Profiles™ / Tocador Cartesian™, Profiles™
18
Publicidad
Capítulos
