Craftsman 919.762500 Manual Del Operador página 10

Gasoline
Your pressure washer engine is 4 cycle. Use unteaded
fuel only.
CAUTION: Do not overfill the fuel tank. Always
allow room for fuel expansion.
WARNING: Never fitl fuel tank indoors. Never
fill fuet tank when engine is running or hot, Do
not smoke or have open flame when filting fuel
tank.
Use clean, fresh, regutar unleaded gasoline with a
minimum of 85 octane. Do not mix oil with gasoline.
If unleaded fue_ is not availaMe, _eaded fuel may be
used.
iMPORTANT: It is important to prevent gum deposits
from forming in essentia! fuel system parts such as the
carburetor, fuel filter hose or tank during storage. Also,
experience indicates that alcohol-blended fuels (called
gasohoi or using ethanol or methanol) can attract mois-
ture which leads to separation and formation of acids
during storage. Acidic gas can damage the fuel system
of an engine while in storage. To avoid engine problems,
the fuel system should be emptied before storage of 30
days or longer. Never use engine or carburetor cleaner
products in the fuel tank or permanent damage may
occur,
NOTE: Never start pressure washer with out water
source turned on and connected to pressure washer.
To Start Your Pressure Washer
Make sure fuel shutoff valve is turned to the open
position.
OFF
FUEL SHUTOFF .,_/X:.iii_-i: - '_)',_
VALVE
Remove gas cap
® Add unleaded gasoline, slowly, to fuel tank.
Do not overfill.
Connect garden hose to the water inlet on the
pressure washer. Tighten by turning water intet
counterclockwise.
Connect high pressure hose to discharge on pump.
Connect the garden hose to the water spout and turn
water supply on.
#! f! I , ; _,,
Squeeze trigger on pressure washer wand to relieve air
pressure caused by turning on the water. Water witI
spew out of the gun in a thin stream. This will make it
easier to start the engine.
® Engage the safety latch on the spray gun. This locks
the trigger in place and keeps you from accidentally
spraying a high pressure stream.
AFETY
ATCH
o On the engine there is a choke!run lever. Place lever
to the choke position.
__-_ _............
-- _ ................ z_:t -_ "_ ........... J
On the engine there is a throttle control tever. Place
throttte to the rabbit position. Always start engine
with throttfe in the rabbit position. Place on/stop
switch to the "on" postion.
ON
Make st_re fuel shut off valve is to the ope_ positio_.
Grasp the starter grip aad pull siow_y _ntit resistance
is felt_ then pull firmly to start engine.
10