Hilti TE 70-AVR Manual De Instrucciones página 12

Weight
Single impact
energy
Ø hammer drill
bits
Ø hammer drill
bits
Ø drill bits for
wood
Ø drill bits for
wood
Ø drill bits for
metal
Ø drill bits for
metal
5 Operation
Fitting the side handle
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened
securely. Check that the clamping band is engaged in the
groove provided on the tool.
Fitting / removing the accessory tool
Note
The use of unsuitable grease may cause damage to the tool.
Use only genuine Hilti grease.
Always check the accessory tool for damage and uneven wear
before each use; replace if necessary.
Drilling without hammering
Note
Drilling without hammering is possible when drill bits with a
special connection end are used. Tools of this kind are avail-
able from the Hilti tools range.
For example, when the keyless quick-release chuck is fitted,
smooth-shank drill bits for wood or steel can be used to drill
without hammering.
8 English
Printed: 02.02.2017 | Doc-Nr: PUB / 5150793 / 000 / 01
TE 70­AVR
18.3 lb
(8.3 kg)
11.5 J
1/2 in ... 1 3/4 in 1/2 in ... 1 3/4 in 1/2 in ... 1 3/4 in
12 mm ...
45 mm
13/32 in ...
1 1/4 in
10 mm ...
32 mm
0 in ... 23/32 in
0 mm ... 20 mm
TE 70-ATC/AVR TE 80-ATC/AVR
20.9 lb
(9.5 kg)
11.5 J
12 mm ...
45 mm
13/32 in ...
1 1/4 in
10 mm ...
32 mm
0 in ... 23/32 in
0 mm ... 20 mm
21.4 lb
(9.7 kg)
11.5 J
12 mm ...
45 mm
13/32 in ...
1 1/4 in
10 mm ...
32 mm
0 in ... 23/32 in
0 mm ... 20 mm
2
3
4