Cool & Warm Mist Dual Tank Ultrasonic Humidifier – Quick Start Guide
How to Fill
CAUTION: Before filling unit with water, turn the power off and unplug the unit from the outlet.
NOTE: Always use two hands to carry the water tank.
Once the tank is full, plug in the humidifier and turn it on by turning the Power/Mist Knob clockwise.
Adjust the mist as desired. To turn the humidifier off, turn the Power/Mist Knob counterclockwise
until you hear a click.
1. Grasp tank handle with both hands and lift up from
humidifier base. Remove only one tank at a time.(Fig. 3)
2. Turn the tank upside down – remove the tank cap by
turning it counter-clockwise. (Fig. 4)
Fill the water tank with clean, cool water. (not cold) We
3.
recommend using distilled water if you live in a hard
water area (Fig. 5)
If desired, add the included demineralization cartridge
directly into the tank
Replace the tank cap by turning clockwise until tight.
4.
(Fig. 6)
5. Install both tanks back on the base of the unit. Make
sure the tanks are firmly seated. (Fig. 7)
NOTE: This unit uses water from one tank at a time. It will
use all the water from one tank before beginning to pull
water from the other tank.
NOTE: It is normal to have a small amount of water in the
base during and after use.
QS-UHECM65A