GALAGAR GALA CUT 350 K G.E. Manual Técnico De Instrucciones página 18

4.2 RECOMMENDATIONS FOR REDUCING ELECTROMAGNETIC COMPATIBILITY (CEM) PROBLEMS.
The user is responsible for the installation and use of the welding material according to the instructions in this
manual and the following recommendations.
Before installing the welding material, the presence of the following in the surrounding area must be kept in
mind:
• Wiring for power, control, signalling, and telephones.
• Radio and television receivers and transmitters.
• Computers and other control equipment.
• Critical security equipment.
• Persons with pace makers or hearing aids.
• Measurement and calibration equipment.
In order to reduce CEM problems, keep in mind the time of day when welding or other activities will be carried
out. Move possible interference victims away from the welding installation. This equipment, according to
CISPR11, concerns group 1 class A.
ALWAYS CONNECT THE MACHINE TO POWER USING AN EFFICIENT GROUND.
IN CASE PROTECTIVE DEVICES OR SUPPLEMENTARY ELECTRICAL SYSTEM FILTERS ARE NEEDED, CONSULT
PERFORM THE MAINTENANCE OPERATIONS DESCRIBED IN THIS MANUAL.
USE THE SHORTEST WELDING WIRES POSSIBLE AND KEEP THEM PLACED NEXT TO EACH OTHER NEAR THE
IN CASE THE WELDING PIECE IS GROUNDED, KEEP IN MIND OPERATOR SAFETY AND NATIONAL
EQUIPMENT DESIGNED FOR USE IN INDUSTRIAL ENVIRONMENT, WHICH MAY POSE DIFFICULTIES WHEN
GUARANTEEING ELECTROMAGNETIC COMPATIBILITY IN OTHER ENVIRONMENTS DUE TO CONDUCTED
GALA CUT 350 K G.E.
CHANGE OF CONSUMABLES
OUR TECHNICAL SERVICE.
AND RADIATED DISTURBANCES.
FORMULA FOR MAKING ORDERS FOR SPARE PARTS:
Indicate:
1 - Machine, Reference and Serial no.
2 - Supply Voltage / Frequency.
3 - No. of parts, description and reference of it.
EXAMPLE:
GALA CUT 350 K G.E., Ref. 509.00.000, Serial no. 07070451
(230-50/60Hz)
1Unit APRIETE CABLE; Ref. 492.16.014
FLOOR.
REGULATIONS.
Pág. 18