Setup And Installation; Rack-Mount Setup - Powerware 9125 Guia De Instalacion

Table 9. Left Rail Kit (53P1963)
Quantity Powerware PN
1 157604171-001
1 157604171-003
1 157604172-001
3 180400027-400
3 180500081-001
3 44700006
Table 10. Right Rail Kit (53P1964)
Quantity Powerware PN
1 157604171-002
1 157604171-003
1 157604172-001
3 180400027-400
3 180500081-001
3 44700006

Setup and Installation

The Powerware 9125 P30 UPS is designed for flexible configurations and can be installed in a
rack, as a standalone cabinet, or in a tower configuration.
NOTE
"Power Cord Connections" on page 12. If you are installing the UPS in an IBM iSeries (0550 or
0551 types) or pSeries (7014 type) rack, continue to the following section, "Rack-Mount Setup." If
you have another type of rack, contact your service representative (see page 20).
NOTE
page 7 to begin the UPS setup.

Rack-Mount Setup

The UPS can be installed in 19-inch racks and needs only 2U of valuable rack space.
NOTE
NOTE
in a rack with existing equipment, the rack must be reconfigured to allow the UPS installation at
the bottom of the rack.
Each UPS and EBM requires one (1) of each item in the following list:
Left rail
Right rail
Rail hardware kit
Rack mounting bracket kit
®
Powerware 9125 (9910 P30) Installation Guide for IBM
Description
Left Fixed Mounting Rail Assembly
Rear Support Rail
Rear Hold-Down Bracket
#10 Split Lock Washer
#10-32 Wing Nut
#10 Flat Washer
Description
Right Fixed Mounting Rail Assembly
Rear Support Rail
Rear Hold-Down Bracket
#10 Split Lock Washer
#10-32 Wing Nut
#10 Flat Washer
For UPS rack installations:
For UPS standalone cabinet or tower installations:
Mounting rails are required for each individual cabinet.
The UPS and any optional cabinets MUST be installed at the bottom of the rack. If placed
Applications S 164201544 Rev A Final 29-Jun-2004
®
If the UPS is pre-installed in an IBM rack, continue to
Continue to "Tower Setup" on
P30 Installation Guide
3