Mixing Fuel; Filling The Fuel Tank - Shindaiwa T282 Manual De Instrucciones

Ocultar thumbs Ver también para T282:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Mixing fuel

CAUTION!
Never use any type of gasoline
containing more than 10% alcohol
by volume! Some types of gasoline
contain alcohol as an oxygenate.
Oxygenated gasoline may cause
increased operating temperatures.
Under certain conditions, alcohol-
based gasoline may also reduce
the lubricating qualities of some
2-cycle mixing oils.
Generic oils and some outboard
oils may not be intended for use in
high-performance 2-cycle engines,
and should never be used in your
Shindaiwa engine.

Filling the fuel tank

WARNING!
Minimize the Risk of Fire
NEVER
smoke or light fires near the
engine.
ALWAYS
stop the engine and allow
it to cool before refueling.
ALWAYS
Wipe all spilled fuel and
move at least 3 meters (10 feet) from
the fueling point and source before
starting.
NEVER
place flammable material
close to the engine muffler.
NEVER
operate the engine without the
muffler and spark arrester screen in
place and in good working condition.
10
CAUTION!
This engine is designed to operate
on a 50:1 mixture consisting of
unleaded gasoline and ISO-L-EGD
or JASO FD class 2-cycle mixing oil
only. Use of non-approved mixing
oils can lead to excessive carbon
deposits.
Use only fresh, clean unleaded gasoline
with a pump octane of 87 or higher.
Mix all fuel with a 2-cycle air-cooled
mixing oil that meets or exceeds ISO-L-
EGD and/or JASO FD classified oils at
50:1 gasoline/oil ratio.
CAUTION!
Mix and pour fuel outdoors where
there are no sparks and flames.
FUEL IS HIGHLY FLAMMABLE.
ALWAYS
store gasoline in a con-
tainer approved for flammable liquids.
ALWAYS
inspect the unit for fuel
leaks before each use. During each
refill, check that no fuel leaks from
around the fuel cap and/or fuel tank.
If fuel leaks are evident, stop using
the unit immediately. Fuel leaks must
be repaired before using the unit.
ALWAYS
move the unit at least 3
meters (10 feet) away from a fuel
storage area or other readily flam-
mable materials before starting
the engine.
Examples of 50:1 mixing quantities
Gasoline
2-cycle mixing oil
liters
2.5 - 1
5 - 1
10 - 1
20 - 1
IMPORTANT!
Mix only enough fuel for your immediate
needs! If fuel must be stored longer than 30
days and
oil with fuel stabilizer is not
used, it should first be treated with a fuel
stabilizer such as STA-BIL™.
Oil is a registered JASO FD classi-fied
oil and also meets or exceeds ISO-L-EGD per-
formance requirements. Shindaiwa One is rec-
ommended for use in all Shindaiwa low emis-
sions engines. Shindaiwa One also includes a
fuel stabilizer.
1.
Place the unit on a flat, level surface.
2.
Clear any dirt or other debris from
around the fuel filler cap.
CAUTION!
Slowly remove the fuel cap only after
stopping the engine
3.
Remove the fuel cap, and fill the tank
with clean, fresh fuel.
4.
Reinstall the fuel filler cap and tighten
firmly.
5.
Wipe away any spilled fuel before start-
ing engine.
milliliters
50 ml
100 ml
200 ml
400 ml

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

T282x

Tabla de contenido