Ridgid Kollmann SeeSnake FlatPack Manual Del Operador página 8

Kollmann
Red Multifunction Button (Figure 6) – This button serves
the following functions:
• Press and quickly release to turn the system power
ON/OFF.
• Press and hold to cycle through the brightness set-
tings of the camera's LED lighting.
• Press and hold for ~1 sec. to activate or de-activate
the In-Line Transmitter (See Table 1 for detailed in-
structions.)
NOTE! The B&W FlatPack uses infrared LEDs that are
invisible to the human eye; changes to the
brightness level will only be visible on the mon-
itor screen.
Multifunction
Button
Video
In/Out Jack
External
Power Jack
Ground Reference (Future Expansion)
Figure 6 – Monitor Pack Rear Panel
Table 1 - Multifunction Button
Button Press Duration
Quick Press and Release (<
Medium Press and Release (
Long Press and Release (>4 sec.)
*LED Indicators - See Figure 6.
6
SeeSnake ® FlatPack and Color FlatPack
Connector for the
Interconnect Cord
Action
1 / sec.) Toggles Power ON/OFF
2
1 / – 4 sec.) Toggles SeeSnake In-Line Transmitter ON/OFF
2
Cycles through LED brightness levels, Release when
desired level is reached.
Ridge Tool Company
LED Indicators (Figure 7) – The LED indicators above
the monitor screen indicate the following operational
conditions:
RED • Steady Glow – Power ON
RED • Steady Flashing – Indicates low battery status
when running off the optional battery pack
RED • Flash S-O-S (3 short, 3 long, 3 short) pattern in
Morse Code – no video signal from the camera
head
WHITE • Steady Flashing – In-Line transmitter is active
RED • Rapid Flashing slowing from 8 to 4 flashes, 2
flashes, 1 flash, While pushing the red multi-
function button, indicates changes to the
brightness level of the camera's LED lighting.
(Table 1)
(Red)
LED Indicators
Figure 7 – LED Indicators
(White)
LED Indicators*
Red - Lit/Unlit
White - Flashes slowly
Red - Rapid flashing slowing
to 4 flashes, 2 flashes, 1 flash