rcf Monitor 33T Manual Del Usuario página 9

Rear Panel Features and Controls
1. This rotary control selects the power tap for the
internal constant voltage transformer. Choices are
1W, 2.5W, 5W, 10W, 20W, and BYPASS (used for
4 ohm operation).
2. This rotary control selects the constant voltage
distributed system in which the speaker is used.
Choices are BYPASS (used for 4 ohm operation), 0
(Off), 25V, 50V, 70V and 100V.
Note: Use a slot-head screwdriver to adjust the
rotary controls.
POWER CAPACITY 30W NOMINAL IMPEDANCE 4
5W 10W
2.5W 20W
1W
MONITOR 33WT
1
25V 50V
0
BYPASS
4
MADE IN CHINA
2
Connections
The spring-loaded speaker terminals are designed
to accept bare wire, up to a maximum of 18 gauge.
Strip 1/4'' (6 mm) of insulation off the end of the spea-
ker wire, press in the tab, and insert the bare wire into
the hole. When you release the tab, the wire is locked
in place. Make sure there are no stray strands of wire
outside the terminal connection.
70V
100V
9
WARNING: To prevent the risk of electri-
cal shock, always fit the protective cover
of the terminals after completing connec-
tions.
+
-