Controls And Display - Hameg Instruments HM6042 Manual Del Usario

C o n t r o l s a n d d i s p l a y

Controls and display

POWER (push button)
Power switch (mains).
INTENS (push button)
Adjust the beam intensity.
FOCUS (push button)
Adjust the beam sharpness.
Display (LCD)
Double spaced LCD indicating measurement results and
selected parameters.
(push buttons)
Select the parameters to be measured
MEMORY (push button)
Store measured values and enable compare function
CURSOR (push button)
Move cursor from curve to curve.
LEDs
Indicates the selected cursor function.
Control knob (rotary knob)
Setting of the test voltages and currents. If the function
is selected, the knob controls the cursor position.
FUNCTION (push button)
Select one of the cursor functions.
INT. LCD (screw)
Adjust the contrast of the LCD.
20
Subject to change without notice
11 12
Y-POS / X-POS (screws)
Adjust the trace in vertical and horizontal position.
13
TR (screw)
Adjust the trace rotation.
14
DUT (push button)
Start/stop test, connect/disconnect the Device Under Test
(DUT)
15
BIP/FET (push button)
Select between bipolar and field effect transistor/diode.
16
NPN/PNP (push button)
Select between NPN and PNP transistors.
17
E/S; C/D; B/G (jacks)
Mechanical and electrical connection for the
DEVICE ADAPTER (HZ820).
18
200, 20, 2 mA (LEDs)
Indicates selected max. test current.
19
I (push button)
max.
Select max. test current.
20
40, 10, 2 V (LEDs, push button)
Indicates selected max. test voltage.
21
V (push button)
max.
Select max. test voltage.
22
4, 0.4, 0.04 W (LEDs)
Indicates selected max. test power.
23
P (push button)
max.
Select max. test power.