Dedicated Micros 2000 Serie Manual De Instalación página 17

Addendum. Optional Autopan
Type 2000 only
Fig.1 Autopan mounting position
Autopan option
(Constant panning facility between limits with a short pause before each change in
direction)
The Autopan assembly mounts, as shown, on pillars above the pan motor. Take care to position the
terminal block facing forward and route the cable loom down one mounting pillar and along the top
gearplate using 'p' clips supplied. Remove the patch plug (fig.2) on the limit board and replace with
the autopan loom connector. Autopan line is pin 6 on the standard 7 way connector.
Fig.2
Patch plug location
2000/2006 Installation Manual
D190 Limit board
Con.4 Patch
plug
Page. 15