Tilt Limits; Set-Up Procedure - Dedicated Micros 2000 Serie Manual De Instalación

7. Tilt limits

The required angular tilt movement of the camera platform can be set to any angle within the range
of +20 Deg to -90 Deg down from the horizontal. A friction clutch design eliminates the need for
tools, simply rotate the actuators by hand to give the desired movement. A graduated scale is
provided on the side arm to aid set-up.
Fig.10 Tilt limits
B
E
C

Set-up procedure

1. Remove the 2 cover fixings (A) and remove the cover moulding (B) to expose the limits beneath.
2. Rotate tilt up (C) and tilt down (D) actuators to give the desired angle of tilt movement.
Note: An angled scale in 10 deg. increments is provided on the platform side arm to aid set up.
3. A limit stop is encorporated to prevent the platform from tilting over +20Deg. & into the
casing (E)
4. The limit pin (F) actuates the internal microswitches to stop the supply to tilt motor.
2000/2006 Installation Manual
A
D
F
Page. 6