Dedicated Micros 2000 Serie Manual De Instalación página 18

Addendum. Optional Low Temperature Heater
Tilt gearbox removed for heater
assembly fitment
Fig.1 Heater mounting position
Heater option
(Thermostatically controlled 75W heater, allowing unit operation down to -30 Deg.C)
The Heater assembly mounts, as shown, beneath the pan motor. Tilt gearbox removal is required
to give access to a fixing screw (shown above). Route cable loom across top gearplate using 'p'
clips provided. Remove the patch plug (fig.2 - previous page) on the limit board and replace with
the heater loom connector. Heater line is pin 6 on the standard 7 way connector.
Type 2006 only
Fig.2 Heater In-Line connector position
2000/2006 Installation Manual
2 way In-line heater
connector secured in plate
Page. 16