Technical Specification; Ordering Information; Ul Compliance Section - RISCO Group WatchIN RK325DT Instrucciones De Instalación

Technical Specification

Electrical
Current consumption (Relay Mode)
Current consumption (BUS Mode)
Voltage requirements
Alarm contacts
AM contacts
Physical
Size:
LxWxD
Weight
Environmental
RF immunity
Operating/Storage temperature
* PIR technology is limited in rough environmental conditions.
** Use a 5A max power supply, using safety-approved wires with a minimum gauge of 20AWG.

Ordering Information

Standard Units
Part Number
RK325DT
The detector contains a standard swivel and a replacement barrier lens (P/N engraved on the Lens -RL327B)
Accessories
Part Number
RA300B
RA300P
RA300C
RA300SC
RA300HS
Camera Accessories
Part Number
WatchOUT VC1
WatchOUT VC017
WatchOUT VC053
WatchOUT VCPS

UL Compliance Section

To comply with UL standards, note the following:

When the detector is connected to the BUS of the ProSYS panel, the detectors are to be
powered from either the ProSYS panel (V7.55) or a listed compatible burglar alarm power
supply that has an output voltage range that does not exceed 9-16 VDC, has a minimum of 4 hours
of standby power, and is suitable for mercantile use.

A dead zone of 2 ft should be considered during installation.

The camera option is not UL listed.

0.6 power factor inductive load can be used on the relays.

Only RK325DT version 10.525GHz is UL approved.

The vibration option is not incorporated on UL listed products.

The maximum range was tested and evaluated by UL with the trimmer set to maximum MW and
ACT settings for PIR.

On power up the detector is not operational for the first 20 seconds.

The detector should be tested by the installer at least once a year.
14
45mA at 12 VDC (Stand by)
60mA at 12 VDC (MAX with LED ON)
30mA at 12 VDC (Stand by),
45mA at 12 VDC (MAX with LED ON)
9-16 VDC**
30 VDC, 1A
24 VDC, 0.1A
215 x 95 x 85mm
(8.5" x 3.75" x 3.35")
0.632 Kg (1.4lb)
40V/m (30MHz to 2GHz)
-10°C to 55°C (14°F to 131°F)
Description
WatchIN DT 10.525GHz / 10.587GHz / 9.9GHz + Swivel
Description
Barrier Swivel Kit
Pole Adaptor Kit
Conduit Adaptor Kit
Swivel Metal Conduit Adaptor
WatchIN Demo
Description
Camera Cover Adaptor 1
NTSC / PAL Narrow Camera For WatchIN
NTSC / PAL Wide Camera For WatchIN
220V / 120V PAL Camera Power supply
WatchIN Installation Manual
Weight
0.1 Kg (0.23 lb)
0.25 Kg (0.55 lb)
0.6 Kg (1.27 lb)
1Kg (2.2 lb)
- -