Check The Pet Door Location Before Installation - Petsafe SmartDoor PPA19-15791 Manual De Adiestramiento

.
STEP 4
Check The Pet Door Location Before
Installation
DO NOT REMOVE SENSITIVITY STICKER BEFORE INSTALLING THE
PET DOOR.
Prior to installation, it is recommended to check that the SmartDoor Electronic Pet Door
™
will operate properly in the intended location or application to guard against possible
severe radio-frequency interference. Household appliances and common electronic
products should be located at least 60 cm away from the Pet Door's location. Radio-
frequency interference detected from other household appliances or common electronic
products will negatively affect the ability of the Pet Door to receive a SmartKey
™
Electronic Key signal. Typical appliances and products to consider are laptop
computers, wireless telephones, microwaves, televisions, garage door openers, hand-
held electronic devices (such as cell phones, game stations and remote controls).
The sticker placed over the sensitivity knob should not be removed until after
installation, as the factory default sensitivity setting is positioned at the optimal level for
most installations.
It is recommended to install the Pet Door in a location where direct wind is not a factor.
Operating Temperature Range: -20.5˚ C to 82˚ C (-5˚ F to 180˚ F). Operating
Humidity Range: 0 to 99.9%.
To check if the Pet Door's radio-frequency technology will operate properly in desired
location and application, place the Pet Door directly in front of and against the door
or application in the upright position. After performing the steps above, set the Pet
Door in AUTOMATIC Mode and hold the SmartKey Electronic Key directly in front of
™
the Pet Door. The Pet Door flap should unlock in about three seconds. Remember, the
SmartKey Electronic Key included in the kit is already programmed to the Pet Door.
™
NOTE: If there are existing SmartKey
Electronic Keys in the household, remove all
™
(RFA-67) batteries while performing step 4 except the SmartKey Electronic Key
™
included with the SmartDoor Electronic Pet Door.
™
If the Pet Door does not unlock, move the Pet Door to another location and repeat the
steps once more. If the Pet Door's location test above was unsuccessful, please call our
Customer Care Centre for additional help.
When the steps above are completed and all are successful, your Pet Door is ready
for installation.
10 www.petsafe.net