Set; Setting The Pet Door Sensitivity Level - Petsafe SmartDoor PPA19-15791 Manual De Adiestramiento

.
Setting The Pet Door Sensitivity
Level
It is necessary to set the sensitivity level of the Pet Door so your pet's SmartKey
Electronic Key works properly due to location or application material, such as radio-
frequency interferences, wood or metal door installations.
To begin, it is recommended to use the split ring (included) to attach the SmartKey
Electronic Key to the D-ring on your pet's collar. Also, do not use metal tags as the
additional metal can cause radio-frequency interference and hinder the detection of
your pet's SmartKey
1. Put the pet's collar on your leg just below your
knee. Tape may be used to secure the collar, if
necessary (A).
2. Stand directly in front of the Pet Door so the
SmartKey Electronic Key is approximately 76
™
cm from the Pet Door.
3. Put the Pet Door in the UNLOCKED Mode. (See
"Operational Modes" section).
4. Put the Pet Door in the Sensitivity Test Mode by
holding down the MODE-RESET and LEARN
buttons at the same time until all three lights
flash once.
5. Turn the Sensitivity Knob anti-clockwise to the
minimum position, then turn the Sensitivity Knob clockwise until all lights begin to
flash again.
6. Slowly continue to adjust the Sensitivity Knob clockwise until you see a minimum of
six consecutive flashes and stop adjusting. Do not adjust higher than necessary.
7. Put the Pet Door in AUTOMATIC Mode and step away at least 3 metres, allowing
the door to automatically lock. This may take up to fifteen seconds after the
SmartKey Electronic Key no longer is detected.
™
8. Now confirm the sensitivity level by approaching the Pet Door again. The door
should unlock when you step within approximately 60 cm in front of the Pet Door.

SET

Electronic Key.
™
www.petsafe.net
A
™
™
15